Versys new project

*After* · 14/12/10, 11:57

Siccome ho gia scrito questo thread, se non si capisce qualcosa dittemmi che lo scrivo in italiano

I am pretty satisfied from my configuration, but i want more

Lets see again the parts i installed

-Both cams from ninja650r/er-6
-Headers from er-6n
-Snorckels out
-Mivv x-cone with cut db killer to 2cm(gives more power to high end)
-14T front sprocket

I didnt do a dyno run, but the bike feels very good for the stock ecu map, and it is very fast for its capacity/cylinder(i had several bikes in the past and i can compare)

I want to do some little mods again, just to renew the love with this bike

-Cams-> intake-> stock versys intake cam
........->exhaust->ninja650r intake cam

-Trim the head for about an 1mm to raise the compression

-PCV+AUTOTUNE with a map of European er6n map(snorckels out + mivv exhaust db killer up)

What do u say about this?

Grazie per leggere tutto, ci sentiamo

14/12/10, 11:57	#1
After Registrato Registrato dal: Feb 2010 Moto: Versys Sesso: Messaggi: 40	Versys new project Siccome ho gia scrito questo thread, se non si capisce qualcosa dittemmi che lo scrivo in italiano I am pretty satisfied from my configuration, but i want more Lets see again the parts i installed -Both cams from ninja650r/er-6 -Headers from er-6n -Snorckels out -Mivv x-cone with cut db killer to 2cm(gives more power to high end) -14T front sprocket I didnt do a dyno run, but the bike feels very good for the stock ecu map, and it is very fast for its capacity/cylinder(i had several bikes in the past and i can compare) I want to do some little mods again, just to renew the love with this bike -Cams-> intake-> stock versys intake cam ........->exhaust->ninja650r intake cam -Trim the head for about an 1mm to raise the compression -PCV+AUTOTUNE with a map of European er6n map(snorckels out + mivv exhaust db killer up) What do u say about this? Grazie per leggere tutto, ci sentiamo